Philip Hertzog, August 6, 2005

NOAA Teacher at Sea
Philip Hertzog
Onboard NOAA Ship Rainier
July 25 – August 13, 2005

Mission: Hydrographic Survey
Geographical Area: Aleutian Islands, AK
Date: August 6, 2005

The processing room

The processing room

Weather Data from Bridge

Latitude: 56˚ 00.3’ N
Longitude: 158˚ 45.7’ W
Visibility:  10 nm
Wind Direction: light
Wind Speed: airs
Sea Wave Height: 0 feet
Sea Water Temperature:  12.2˚ C
Sea Level Pressure: 1006.0 mb
Cloud Cover: 1, cumulus, altocumulus

Science and Technology Log 

I spent the afternoon in the plot room behind the bridge.  After collecting data on the launches, the hydrographic technicians need to process and make it usable before sending the information to map makers in Washington, D.C.  This processing takes place in the plot room.

The plot room has a large table in the middle with eight work stations crowded around the outer edge of the room.  Each work station has two computer screen monitors where the technician can pull up multiple windows. The room has a couple of portholes to provide light, though these can be shaded to make the monitors more visible. I observed the Ensigns and survey technicians concentrating on their work.  The plot room impressed me as the quietest location on the RAINIER with people clicking on their computer screens and checking their data for accuracy.  Once in a while one of the technicians got up to ask another for clarification on a problem.  The four people in the room all wore headphones to listen to CD or mp3 players.

Processing the data

Processing the data

The technicians processed data by first “cleaning” it up. The hydrographers put the sonar data up on the screen and looked for mistakes in the readings.  Mistakes can occur by the launch computer skipping measurements or missing a GPS satellite signal.  The plot room computers also adjust for the movement of the launches in several directions caused by buffeting seas. After cleaning data, the crew corrected the sonar readings for sound velocity by using the CTD probe readings taken from the launches. As noted previously, the speed of sound in water is affected by conductivity (a measurement of salt content), temperature and density). The CTD data is used to correct the sea bottom depth readings obtained from sonar. The technicians made one final correction to the sonar data by loading in tidal information to adjust for the height of the launch above mean lower low water.  With the corrected sonar data, three-dimensional maps can now be generated and the hydrographer gets a picture of the ocean bottom over a wide area.  Additional work will be done before the information is sent on to the chart makers off the ship.

After supper I went up to the plot room to get some photographs for this log entry.  To my surprise, Ensigns filled every work station and I saw them checking on today’s data.  The Ensigns discussed with Lt. Ben Evans the strategy for tomorrow’s mapping.  What dedication! It’s Saturday night, yet the work never stops for the hard working crew of the RAINIER. Too bad for them, I’m going fishing now!

The hydrographers highlight the incorrect data and click on it to remove it

The hydrographers highlight the incorrect data and click on it to remove it

Personal Log 

I had a very quiet day. The routine on a research vessel like the RAINIER is a mix of excitement and concentrated computer work.  The crew averages about one day of cleaning and processing data for each day of collecting data on the launch.  Though the computer work may seem tedious at first, think about the sense of accomplishment when you see your data become a three-D map of the ocean bottom and know that other people will use your work.

I hope my own students will recognize that hard work can pay off and provide a sense of accomplishment and purpose.  The crew of the RAINIER has provided me with examples to show my middle school students that they can balance exciting work with hard dedication to make a meaningful difference to society.

Question of the Day 

Why must the hydrographers carefully check their data for mistakes? What can happen if a mistake is made on a nautical chart?

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s